CZ P-10C OR plates

CZ P-10C Optics Ready (OR) plates adapt the factory OR slide to a specific red-dot footprint and keep the optic low, rigid, and zeroed.

Which footprint do you need?

• Trijicon RMR footprint
• Shield RMSc footprint
• Holosun K-series footprint
• Leupold DPP footprint
• C-More RTS footprint
• Vortex Venom footprint
• Aimpoint ACRO footprint

Quick setup checklist

• Confirm you have a CZ P-10C Optics Ready slide.
• Select the plate that matches your optic’s footprint (see list above).
• Apply Loctite threadlocker to clean, degreased screws.

Installation basics

• Degrease mating surfaces and hardware; use threadlocker.
• Torque to the manufacturer spec for plate-to-slide and optic-to-plate screws.
• Verify screw length and thread pitch; witness-mark and recheck after the first range session.

Not “Optics Ready”?

You can still mount a red dot without milling by using a dovetail red dot mount that replaces the rear sight.